Reactive Extrusion Additive Manufacturing with Continuous Fiber Reinforcement: Process Development and Composite Characterization
Year: 2026
Type: article
Abstract: Utilizing reactive extrusion additive manufacturing (REAM) to produce composite parts is a relatively unexplored area of research. The introduction and effectiveness of continuous fiber reinforcement in additive manufacturing requires a delicate balance of process parameters, including line spacing, layer height, deposition rate, and nozzle design. This study established the baseline parameters needed to produce REAM composite samples using two two-part reactive polymer resin systems and two reinforcing fibers. A venturi nozzle with internal agitation nodes was developed to introduce the continuous fiber to the REAM process and improve fiber wet-out. Material characterization revealed tensile modulus and strength increases of 1219% and 276%, respectively, for a composite containing 8.29% glass fiber—the highest fiber volume percentage achieved in this study. A basalt composite with 2.19% fiber and 13.2% voids by volume—the highest void percentage found—had a flexural strength of 35.3 MPa, a 233% increase compared to its unfilled resin system. Material characteristics, including fiber tow size, fiber sizing, resin viscosity, and resin gel time, contributed to overall composite and process performance. These findings and the processes developed in this study provide a foundation for future research aimed at improving the quality, performance, and complexity of REAM composites.
DOI: 10.3390/jmmp10110472
Institution: North Dakota State University
Language: English
Subfield: Automotive Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $2,172
OpenAlex ID: W7225153408