Microstructure engineering of sol–gel SiO 2 coatings with biomass derived carbon dots for enhanced corrosion protection of stainless steel
Year: 2026
Type: article
Abstract: -0.003PP-CDs coating exhibited the most continuous microstructure, maintaining its integrity after immersion in 1.0 M HCl, whereas the undoped coating underwent severe cracking and delamination. Electrochemical measurements (EFM, PDP, and EIS) gave the same ranking, with inhibition efficiencies of 84-86% (EFM and PDP) for the 0.003 mg coating compared with 50-53% for undoped silica. EDS, contact angle, and AFM results were consistent with better retention of the 0.003 mg coating after immersion. The improvement over the undoped coating is primarily attributed to the addition of PP-CDs, which is accompanied by a change in film morphology and microstructure, from a cracked, agglomerated film to a continuous, more homogeneous one at 0.003 mg. These findings indicate that biomass-derived carbon dots can improve the short-term corrosion resistance of sol-gel silica coatings on stainless steel in hydrochloric acid under laboratory conditions.
Source: RSC Advances
DOI: 10.1039/d6ra08713b
Authors: H. A. Siam(Data curation, Formal analysis, Investigation, Validation, Writing – review & editing), R. Helmy(Data curation, Formal analysis), M. Saif(Conceptualization, Data curation, Formal analysis, Visualization, Writing – original draft, Writing – review & editing), Amr Gangan(Formal analysis, Validation), N. S. Abdelshafi, Hanan A. Soliman(Data curation, Formal analysis)
Institutions: Ain Shams University, Al-Azhar University
Language: English
Subfield: Materials Chemistry
Field: Materials Science
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $1,042
OpenAlex ID: W7225613964
