Work

Hold-Off Time, Afterpulsing and Maximum Count Rate for a Single-Photon Avalanche Diode

Year: 2026
Type: article
Abstract: After an avalanche, a single-photon avalanche diode must be held off while trapped carriers clear. A short hold-off raises the maximum count rate and also raises the probability that the next event is an afterpulse rather than a photon. This study computes the quantities that follow from stated assumptions for a silicon avalanche diode at 780 nm with trap lifetime 80 ns, initial afterpulse probability 0.30 at zero hold-off, and dead-time-limited counting, using the relations set out in the Methods. The headline results are afterpulse at 100 ns = 0.08595, afterpulse at 400 ns = 2.021e-03, holdoff for 1pct ns = 272.1, max rate at 1pct Hz = 3.675e+06, max rate at 100 ns Hz = 1.000e+07. The central question is stated as follows: What hold-off time balances a stated afterpulse budget of one percent against count rate, for a trap lifetime of 80 ns, and what timing jitter and efficiency does the resulting operating point imply? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Commercial and laboratory avalanche detectors quote maximum rates from a few megahertz to tens of megahertz, with afterpulse probabilities from below one percent to several percent depending on hold-off. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Language: English
Subfield: Instrumentation
Open Access status: green
OpenAlex ID: W7225875514
FWCI: 2.365
Cites:
Cited by: 1
Related to: 10