Design and Optimization of 3D Printed ASA Substrate Based Antenna for Wi-Fi 6E
Year: 2026
Type: article
Abstract: This paper presents design, optimization, and fabrication of a wideband microstrip patch antenna utilizing a 3D-printed acrylonitrile styrene acrylate (ASA) substrate for Wi-Fi 6E frequency band. The dielectric properties of the ASA substrate are determined using the ring resonator method. The bandwidth enhancement is achieved by modifying the conventional rectangular patch into a staircase-shaped structure and employing a partial ground plane. To fine-tune the antenna’s resonant frequency and bandwidth, a combination of curve fitting and particle swarm optimization (PSO) algorithm is utilized. The antenna comprises a patch with dimensions of 16.86 mm × 12.5 mm, situated on square substrate of size 27.5 mm × 27.5 mm. The antenna demonstrates a -10 dB impedance bandwidth ranging from 5.98 GHz to 8.62 GHz and a peak gain of 3.6 dBi at 6.525 GHz. Simulation and experimental results show good agreement, highlighting the potential of ASA as a viable substrate material for Wi-Fi 6E band antenna applications.
Source: Electronics ETF
DOI: 10.53314/els2630094m
Language: English
Topic: Antenna Design and Analysis
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7225875542
