Work

Polyalcohol Liquefaction of Loquat (Eriobotrya japonica) Seeds: Liquefaction Yield and Hydroxyl Index

Year: 2026
Type: preprint
Abstract: Loquat (Eriobotrya japonica) seeds are an abundant agro-industrial residue with considerable potential for conversion into value-added bio-based products. This study investigated the chemical composition and polyalcohol liquefaction of loquat seeds, with particular emphasis on the effects of temperature, reaction time, particle size, and solvent-to-biomass ratio on liquefaction yield and the hydroxyl (OH) index of the resulting bio-polyols. The seeds exhibited a carbohydrate-rich composition, containing 60.41% holocellulose, including 21.68% α-cellulose and 38.73% hemicelluloses, while total lignin accounted for 12.72%. A high hot-water extractive fraction (18.19%) was also observed, which may include soluble carbohydrates and part of the starch fraction not quantified separately by structural analysis. Liquefaction efficiency increased with increasing temperature and reaction time, reaching approximately 88% at 180 °C and 60 min. Reduction of particle size also substantially improved liquefaction, with the yield increasing from approximately 65% for particles >40 mesh to 88% for particles <80 mesh. Increasing the solvent-to-biomass ratio from 1:3 to 1:10 similarly enhanced liquefaction yield, although the increase became progressively less pronounced at higher solvent contents. In contrast, the OH index decreased with increasing temperature and reaction time, reaching approximately 920–925 mg KOH g⁻¹, whereas higher solvent-to-biomass ratios substantially increased the OH index to more than 900 mg KOH g⁻¹. Overall, the results demonstrate that loquat seeds are highly susceptible to polyalcohol liquefaction, owing to their high carbohydrate and extractive contents and relatively low lignin content. FTIR-ATR analysis supported the formation of hydroxyl-rich, oxygenated polyol products and revealed temperature-dependent changes in lignin-derived aromatic structures in the liquid fractions. A solvent-to-biomass ratio between 1:5 and 1:7 may provide a practical balance between liquefaction efficiency, polyol hydroxyl functionality, and solvent consumption, supporting the potential use of loquat seeds as a renewable feedstock for bio-based polyols and polyurethane-related applications.
Language: English
Subfield: Catalysis
Open Access status: green
OpenAlex ID: W7225996988
Cites:
Cited by:
Related to: 10