Work

Hybrid Rapid Tooling for Centrifugal Pump Impellers: Influence of Additive Mould Topography and Post-Processing on Wax Pattern Accuracy

Year: 2026
Type: article
Abstract: This article proposes a hybrid concept for rapid tooling in investment casting for the impeller of the CH 100/32-15-1 sealed centrifugal pump, which overcomes the dimensional limitations of 3D printing and reduces tooling costs. The moulding elements of the discs are manufactured by turning, whilst the complex-shaped three-dimensional blades are produced using additive manufacturing methods. A comparison was carried out between eight configurations of polymer moulds (SLS using PA-12 and FDM using ABS with 0.2 and 0.4 mm nozzles, without post-processing, after mechanical polishing and smoothing with acetone vapour) and a reference industrial aluminium mould. The surface roughness of the working cavities was measured using a Form Talysurf Intra profilometer (12 traces per mould), whilst the geometry of the resulting wax patterns was checked using a Creaform HandyScan 700 Elite 3D scanner to analyse the hydraulic surfaces of the blades. The use of untreated PA-12 (Ra = 3.335 ± 0.358 µm) caused chipping of two out of five wax patterns during removal, whilst mechanical polishing reduced Ra to 0.157 ± 0.031 µm, surpassing the aluminium reference standard (0.247 ± 0.043 µm) in terms of roughness. The proportion of the blade area within the ±0.100 mm tolerance range was 86.1% for the aluminium mould and 12.4–53.9% for the polymer moulds (with the highest value for the polished PA-12), with a systematic positive deviation observed in all printed samples. Thus, polished SLS moulds made from PA-12 represent a cost-effective solution for prototyping and small-batch production of wax blade patterns, provided that warpage is taken into account.
Language: English
Open Access status: gold
Estimated APC paid: $2,896
OpenAlex ID: W7226001964
FWCI:
Cites: 29
Cited by:
Related to: 10