Work

Shape Targets for Lunar Regolith Preprocessing: A DEM Study of Roundness, Elongation and Angle of Repose

Year: 2026
Type: preprint
Abstract: Rounding angular lunar regolith grains has been proposed to reduce abrasion on processing hardware (Shergill and Kingston, 2019), but its effect on flow has not been quantified as a design target. We used GPU discrete element simulations (Chrono DEM-Engine) of 2 mm multi-sphere grains to map the angle of repose in a quasi-2D slump test across four Wadell roundness levels (0.13 to 1.0) and three aspect ratios (0.6 to 1.0), with two seeds per shape. Contact parameters were calibrated so a reference angular grain gives 39.3 ± 0.4°, close to the 39.6° reported for the LHS-1 simulant. Across the grid the angle ranged from 39.4° (angular, elongated) to 30.6° (sphere). The four grid cases in the nominal roundness ≥ 0.8 and aspect ratio ≥ 0.8 corner settled at 30.6 to 33.5°, about 3 to 6° below crushed-like angular grains at aspect 0.8 (36.9°). Rounding did little for elongated grains: at aspect 0.6 the angle stayed between 36.2° and 39.4° at every roundness. A linear surface in roundness and aspect ratio gave a leave-one-out RMSE of 1.6°. Runs at lunar gravity for three shapes agreed with Earth gravity within 1.3°, with no gravity effect resolved. We propose nominal roundness ≥ 0.8 and aspect ratio ≥ 0.8 as a provisional shape target for regolith preprocessing, to be checked against laboratory tests. Shape templates, parameters, scripts and outputs are released openly.
Author: Luis Torres
Language: English
Open Access status: green
OpenAlex ID: W7226008722
Cites:
Cited by:
Related to: 10