The Influence of Support Roughness on Shape Distortion of Binder-Jetted Parts During Sintering—Experimental and Modelling Analysis
Year: 2026
Type: article
Abstract: In recent years, metal binder jetting (MBJ) has seen increasing adoption in diverse manufacturing sectors due to its scalability, design flexibility, and high cost-efficiency. Sintering the green part at high temperature is an essential step to obtain a nominal product; nonetheless, it may detrimentally affect dimensional and geometrical accuracy, as parts with complex geometries undergo shape distortion because of gravity and/or friction at the contact area with the sintering trays. This study aimed to investigate the friction-induced deformation of sintering stainless-steel 316L thin-walled cubes on alumina supports with different surface finishing; arithmetic average roughness (Ra) and Maximum Height of the Profile (Rz) ranged from 0.2 to 12 μm and 3 to 60 μm, respectively. The deviation in the sintered cubes, measured using a Coordinate Measuring Machine (CMM), did not show a clear pattern as a function of surface finishing. Finite Element Modelling (FEM) confirmed that shape distortion during sintering marginally increases with an increase in the friction coefficient. Assuming a heterogeneous initial density distribution, the simulation results showed good agreement in predicting the concave deformation patterns observed in many samples (~0.45 mm, less than 5% error along the y-direction). This work proposes novel insight into the influence of tray roughness and the combined effect of friction and density distribution on shape distortion during sintering.
Source: Metals
DOI: 10.3390/met16111250
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W7226011610
