Work

Effect of Pulse-Duration Ratio on Microstructural Evolution, Mechanical Properties, Phase Transformation, and Corrosion Resistance of Autogenously DPTIG-Welded Nitinol Sheets

Year: 2026
Type: preprint
Abstract: Joining thin Nitinol sheets remains challenging because the thermal cycles associated with fusion welding can substantially alter their microstructure, mechanical properties, phase transformation behaviour, and corrosion resistance. In this study, 1 mm-thick Nitinol sheets were autogenously welded using double-pulse tungsten inert gas (DPTIG) welding to investigate the effects of pulse-duration ratio on weld bead geometry, microstructure, mechanical properties, phase transformation behaviour, and corrosion performance. Three pulse-duration ratios (50–50%, 40–60%, and 60 − 40%) were investigated. Full penetration was achieved under all welding conditions, while the 40–60% condition produced the narrowest weld bead and promoted grain refinement. The fusion zone predominantly comprised B2 austenite with columnar grains, alongside the formation of Ti₂Ni and Ni₃Ti intermetallic phases. Among the investigated conditions, the 40–60% ratio yielded the finest average grain size (24 ± 2 µm), the highest high-angle grain boundary (HAGB) fraction (76%), and the highest tensile strength (583 ± 11 MPa), representing an approximately 3% improvement over the 50–50% condition. Differential scanning calorimetry (DSC) revealed the B2-B19′ martensitic transformation, with no discernible R-phase transformation peak. In contrast, the 60 − 40% condition exhibited the lowest corrosion rate of 0.00402 mm/year. These findings demonstrate that pulse-duration ratio influences weld geometry, microstructural evolution, tensile performance, phase transformation behavior, and corrosion resistance in DPTIG-welded Nitinol sheets, highlighting its potential as a process parameter for tailoring the properties of welded Nitinol components.
Language: English
Open Access status: green
OpenAlex ID: W7226036078
Cites: 28
Cited by:
Related to: 10