Dynamic Spatial Programming of Active–Active Antagonistic Fiber Architectures for Enhanced Morphing
Year: 2026
Type: article
Abstract: Programming multiple deformation modes within a continuous liquid crystal elastomer (LCE) filament remains challenging because molecular alignment and active-material distribution are typically coupled to the external printing path. Here, a rotational multimaterial printing strategy is introduced that encodes two co-curable LCE phases with opposite free thermal strains within individual fibers. These antagonistic free strains act cooperatively after co-curing to generate internal strain mismatch and structural deformation. A dual-channel rotating nozzle co-extrudes a thermally contracting nematic LCE and a thermally elongating smectic LCE, while nozzle angle, angular velocity, and flow-rate ratio prescribe their cross-sectional and axial distributions. Discrete and continuous rotation enable contraction, elongation, in-plane bending, out-of-plane curling, and helical coiling without changing the filament centerline. Under matched conditions, the active-active fibers exhibit an approximately 1.6-fold increase in curvature relative to the active-passive controls, while simultaneous co-curing increases interfacial peel strength by approximately 30 times that achieved by sequential curing. The same encoding strategy extends from individual fibers to grids and Gaussian-curvature surfaces and enables force-generating strips, thermal protection, self-sensing, particle sorting, and adaptive gripping. Rotational multimaterial printing therefore decouples intra-filament architecture from toolpath geometry and provides a general route to spatially programmable active fibers.
Source: Advanced Materials
DOI: 10.1002/adma.75697
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: bronze
Awards: G3716622270, G5202064047, G9001369013
OpenAlex ID: W7228098634
