Work

Deployable Umbrella Drag-Modulation Aerocapture at Venus: Two-State Ballistic-Coefficient and Corridor Budgets

Year: 2026
Type: article
Abstract: This paper presents a computed design study of a planetary entry system on a single stated operating principle: a deployable umbrella-like drag skirt gives the spacecraft two discrete ballistic coefficients — skirt deployed for the deep, high-drag part of the pass and skirt jettisoned to raise the ballistic coefficient and exit — so the exit energy is controlled by the timing of a single jettison event rather than by continuous lift modulation. The system is a 980 kilogram Venus orbiter with a 7.0 metre deployable umbrella drag device, arriving with a hyperbolic excess speed of 3.40 kilometres per second and targeting a captured apoapsis altitude of 8,000 kilometres. The design target is capture at Venus, where the dense atmosphere and high arrival speed make a fixed-geometry corridor narrow, using the two-state drag change to widen the effective corridor. The design periapsis is 160 kilometres, the corridor is 3.75 kilometres wide, peak deceleration is 4.77 Earth gravities, peak heating is 65.9 watts per square centimetre, the heat load is 31.7 megajoules per square metre, and the thermal protection mass is 63.1 kilograms, a fraction 0.064 of the arrival mass. The purpose throughout is civilian planetary science: landing or orbiting instruments that measure another world's atmosphere, surface and environment. Nothing in the design is optimized for any other use, and the study has no targeting or weapon application. It is a computed study; every performance figure is simulated from the stated assumptions, not measured.
Language: English
Open Access status: green
OpenAlex ID: W7233419182
FWCI:
Cites:
Cited by:
Related to: 10