A supercapacitor-assisted cyclic battery recharging method for solar and wind power systems
Year: 2026
Type: article
Abstract: The efficient use of solar and wind electricity in stand-alone power systems for remote facilities is limited during periods of reduced generation, when the source voltage may fall below the activation threshold of the charge controller. Under such conditions, direct battery recharging becomes impossible despite the availability of residual energy from the renewable source. This paper investigates a cyclic battery recharging method based on preliminary energy accumulation in supercapacitor modules and their subsequent discharge into the battery. The proposed approach was evaluated using a MATLAB/Simulink simulation model and a physical experimental setup with 166 F and 500 F supercapacitor modules and lead-acid batteries. The results show that preliminary energy storage in supercapacitor modules followed by controlled discharge enables additional battery recharging when the source voltage is insufficient for direct charging through the controller. For the 166 F modules, the duration of the complete first cycle was approximately 8.3 min, while for the 500 F modules it was approximately 28.5 min. Repeated cycles started from the residual voltage of the supercapacitor modules, which reduced the duration of the subsequent charging stages. The deviation between the simulated and experimental voltage characteristics did not exceed 3.5% in the most important operating regions and remained below 7.4% in the other regions. The proposed method is based on voltage-threshold switching logic; in the physical setup, switching was performed manually, while automated implementation is considered as a direction for future research.
DOI: 10.18686/cest948
Language: English
Subfield: Energy Engineering and Power Technology
Field: Energy
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7233578150
