Experimental Thermal–Hydraulic Evaluation of Continuous and Notched-Fin Liquid–Suction Heat Exchangers in an R407C Freezing System
Year: 2026
Type: article
Abstract: Liquid–suction heat exchangers subcool the liquid line of a refrigeration cycle and protect the compressor, but in small freezing units their duty is usually limited by weak heat transfer on the suction-vapor side. This study adds a longitudinal fin on that side and examines whether notching the fin improves it further. In each of three exchangers, a copper fin 10 mm high and 1 mm thick was brazed under the liquid line and inserted through a slot into the suction line over a 600 mm contact length. The fin was continuous or carried 9 or 17 notches, each 5 mm wide and 5 mm deep. Each exchanger was installed in turn in an R407C freezing system serving a 15 m³ cold room and compared with the same cycle without an exchanger at evaporating temperatures from −25 to −10 °C. The effectiveness rose with the number of notches, reaching 0.14, 0.28 and 0.38 at −10 °C, although the notches removed up to 5.4% of the fin area. At −25 °C, the coefficient of performance increased from 2.59 to 2.80, 3.03 and 3.18, the refrigeration capacity of the 17-notch exchanger rose from 4.96 to 5.35 kW, and the compressor work fell by up to 12.4%. The metered daily energy use dropped by 5.7%, 7.3% and 10.4%. The cost was a higher suction-side pressure drop, which reached 7.6 kPa with 17 notches, so the notch density should be chosen against the suction pressure loss that the compressor can accept.
Author: Ayad Dawood Sulaiman
Institution: Northern Technical University
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7233610109
