Work

Effect of Extrusion Binder on the Structure and Propane Dehydrogenation Performance of Pt-Sn Catalyst Bodies

Year: 2026
Type: article
Abstract: Pt-Sn catalysts for propane dehydrogenation (PDH) have been widely studied in powder form; however, the combined effects of binder type and content on the shapeability, structural integrity, and catalytic behavior of extruded Pt-Sn catalysts for PDH remain largely unexplored. Commercial γ-Al2O3 and hydrotalcite-derived Mg(Al)O pellets were compared with hydrotalcite-rich extruded bodies formulated using boehmite-derived alumina or sepiolite binders. The results revealed that binder selection affected extrusion feasibility, pore architecture, mechanical strength (crushing strengths of 3.0–15.0 N/mm for the selected extrudates), and the radial distribution of the metal phase. Among the investigated systems, the hydrotalcite-derived Mg(Al)O reference exhibited the most favorable PDH performance (~30% propane conversion, close to equilibrium, with an apparent ~4% activity loss over 12 h), while the γ-Al2O3-supported catalyst showed the lowest propane conversion and selectivity. The extruded composites delivered intermediate performance, and increasing the boehmite content from 10 to 30 wt.% increased the coking rate fivefold. Notably, the hydrotalcite–sepiolite catalyst maintained stable conversion and ~94% propylene selectivity despite a higher coking rate, which TEM-EDX associated with coke deposition on the support rather than on the Pt-Sn particles. Overall, binder selection is a key factor controlling the structural, mechanical, and catalytic properties of extruded Pt-Sn catalyst bodies and reveals a trade-off between mechanical integrity and catalytic performance.
Source: Catalysts
Language: English
Subfield: Catalysis
Open Access status: gold
Estimated APC paid: $2,654
OpenAlex ID: W7233859378
FWCI:
Cites: 45
Cited by:
Related to: 10