Manufacturing Large-Area Perovskite Photovoltaics by Blade Coating Porous PbI2–N-Methyl-2-Pyrrolidone Intermediates
Year: 2026
Type: article
Abstract: Manufacturing perovskite photovoltaics over large areas requires a coating and conversion sequence that remains effective as the substrate width increases. Here, a blade-coated lead iodide intermediate containing N-methyl-2-pyrrolidone (NMP) and dimethyl sulfoxide (DMSO) was thermally restructured into a porous PbI2–NMP scaffold before immersion in a formamidinium iodide/methylammonium chloride solution. The blade gap and substrate translation speed were fixed at 150 μm and 20 cm min−1, respectively, while the post-coating heating time at 60 °C was varied from 0 to 10 min. X-ray diffraction of reference solvent-complex films suggests that mild heating preferentially removes the DMSO-associated fraction while the NMP-coordinated intermediate is retained, thereby opening infiltration pathways through the precursor layer. A 5 min treatment produced the most favorable balance between scaffold opening and suppression of crystalline PbI2, yielding larger perovskite grains and a time-resolved photoluminescence lifetime of 1224 ns, 2.8 times that of the unheated reference. Devices manufactured with this process achieved champion power conversion efficiencies of 25.40%, 23.25%, 22.08%, and 21.09% at device areas of 0.0803, 1, 25, and 64 cm2, respectively. These results identify intermediate-layer restructuring as a practical process-control step for transferring blade-coated perovskite fabrication from laboratory cells to larger photovoltaic modules.
Source: Nanomaterials
DOI: 10.3390/nano16221481
Institutions: Korea Institute of Energy Research, Pusan National University
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $2,896
Awards: G2418115107, G4878700703
OpenAlex ID: W7233914307
