Work

Influence of the Hematite/Limonite Ratio on Sinter Properties and the Underlying Microscopic Mechanism

Year: 2026
Type: article
Abstract: China’s iron and steel industry relies heavily on imported ores, whose hematite/limonite blending ratio markedly affects sinter strength and metallurgical properties; however, how the ratio acts through microscopic mineral phases remains insufficiently clarified. To this end, six imported iron ore fines were characterized for their high-temperature bonding phase properties (compressive strength of compacts roasted at 1280 °C), and seven gradient ratio schemes (30–60% limonite) were designed for sinter pot tests; the sinters were analyzed by XRD, optical microscopy and SEM-EDS. The bonding phase strength of hematite-type fines was on average higher than that of limonite-type fines (1364.14 N vs. 1011.15 N), although some limonite fines are heavier than some hematite fines. Techno-economic indices and metallurgical properties responded asynchronously to the ratio: the highest yield, productivity coefficient and vertical sintering speed were obtained at 45% limonite, whereas RDI+6.3 deteriorated sharply at 60% limonite (falling from 51.97% at 55% to 43.16%). Fe2O3 content first decreased and then increased with the limonite ratio, and reduction degradation was governed by the mode of occurrence of Fe2O3 rather than its total content; skeletal secondary hematite recrystallized from the liquid phase triggered crack propagation during reduction. Accordingly, limiting the limonite proportion to 40–45% (not exceeding 55%) while promoting acicular silico-ferrite of calcium and aluminum (SFCA) and suppressing skeletal secondary hematite is recommended for industrial ore blending.
Source: Metals
Language: English
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W7233966828
FWCI:
Cites: 10
Cited by:
Related to: 10