Work

Low-Temperature, Large-Area Sinter-Bonding of Dendritic Cu Paste for Substrate-to-Base-Plate Joints

Year: 2026
Type: article
Abstract: For large-area substrate-to-base-plate joints in power modules, low-temperature Cu particle sinter bonding can offer a low-cost and high-thermal-conductivity alternative to soldering. Studies on large-area, low-temperature Cu sinter bonding remain scarce. In this study, ultrafine dendritic Cu particles were synthesized via a wet-chemical route and formulated into a Cu paste using a reducing vehicle. This paste was used for large-area (12 mm × 12 mm) pressure-assisted sinter bonding at 220 °C in air. The filler exhibited a median particle diameter of 4.68 μm and a Brunauer–Emmett–Teller surface area of 9.36 m2/g, reflecting a hierarchical architecture with nanogranule-decorated branches. Large-area joints achieved shear strengths of 35.1 and 70.6 MPa (at 15 MPa for 1 and 10 min) and 59.4 MPa (at 10 MPa for 5 min), surpassing small-area counterparts (3 mm × 3 mm) and reported large-area values. This high performance stems from rapid interfacial necking and <10% bond-line porosity within 3 min. Spatially resolved shear testing and scanning acoustic tomography identified edge-localized voiding and oxidation as dominant causes of reduced peripheral strength. These findings suggest that dendritic Cu pastes exhibit considerable potential as a low-cost, agglomeration-resistant option for low-temperature, large-area die attachment applications in power modules.
Source: Metals
Language: English
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W7234024178
FWCI:
Cites: 33
Cited by:
Related to: 10