Improving the Lateral-Resistant Behavior of Steel Plate Shear Walls with CFST Columns Using Two-Layer Flat-Corrugated Plates
Year: 2026
Type: article
Abstract: Utilizing flat plates (FPs) in a steel plate shear wall (SPSW) system significantly pinches the hysteresis curves, as these plates are highly susceptible to out-of-plane buckling. In this study, a flat-corrugated plate (FCP) was used in an SPSW system with concrete-filled steel tubes (CFST) columns. In this study, an earlier evaluated traditional flat SPSW with CFST columns was validated in ABAQUS software under cyclic loads. Then, by introducing a two-layer FCP that encompasses both a flat and a trapezoidal corrugated plate, instead of an flat plate (FP), the effects on the hysteresis curve and structural parameters were investigated. The results showed that using an FCP instead of a traditional FP in an SPSW system (FCSPSW) with CFST columns led to a fatter hysteresis curve and, subsequently, a significant improvement in energy dissipation. The maximum resistance of the FCSPSWs with CFST columns was slightly higher than that of the control sample. The results showed that the use of an FCP has a minimal effect on the elastic stiffness.
Authors: Huanqing Jiang, Dongyu Ji, Xingpei Wang
Institution: Hunan Urban Construction College
Language: English
Subfield: Civil and Structural Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7234323716
