Microstructural Inhomogeneity Complicates Small‐Scale Fracture Toughness Testing of Ceramic Nanocomposites
Year: 2026
Type: article
Abstract: Ion‐implantation effects in ceramics and composites are surface‐localized to a few microns. Therefore, measurements of the mechanical properties, such as fracture toughness, of ion‐implanted ceramics and composites necessitate the use of microscopic specimens. While techniques such as microcantilever beam bending and micropillar splitting are often used to test microscopic specimens, critically comparing the results from these two techniques is important. Here, the micropillar splitting technique was used to measure the fracture toughness of monolithic SiC (1.94 ± 0.27 MPa·m 1/2 ) and carbon nanotubes (CNTs)‐reinforced SiC nanocomposites before and after C 2+ ion implantation. These results are compared with fracture toughness values previously measured for the same materials using the microcantilever beam bending technique. There is good agreement between the fracture toughness of monolithic SiC measured by micropillar splitting and microcantilever beam bending (~1.94 vs. ~2.42 MPa·m 1/2 , respectively, for the nonirradiated condition), as well as with literature values. However, the fracture toughness of the nanocomposites measured by the micropillar‐splitting technique was consistently lower than that obtained by microcantilever beam bending, both under nonirradiated conditions (~0.99 vs. ~2.70 MPa·m 1/2 , respectively) and after irradiation (~1.55 vs. ~4.76 MPa·m 1/2 , respectively). This difference was attributed to the pronounced microstructural inhomogeneity resulting from CNT addition and ion implantation.
Source: Advanced Engineering Materials
DOI: 10.1002/adem.71425
Language: English
Subfield: Materials Chemistry
Field: Materials Science
Domain: Physical Sciences
Open Access status: bronze
Awards: G105670245, G2635648197
OpenAlex ID: W7234999443
