Effect of die-exit argon-gas cooling on microstructure, texture, mechanical properties, and in vitro degradation behavior of extruded Mg–Zn–Mn–Sr microtubes
Year: 2026
Type: article
Abstract: Mg alloy microtubes for bioresorbable vascular stents require dimensional accuracy, adequate room-temperature tensile properties, and predictable degradation behavior. In this study, Mg–1.07Zn–0.49Mn–0.52Sr (wt%) alloy microtubes were fabricated by two-step direct extrusion without (NC) and with die-exit argon-gas cooling (AGC). Both conditions produced microtubes with an outer diameter of approximately 2.1 mm and a wall thickness close to 0.20 mm. AGC modified the monitored subsurface near-exit die-temperature history, but the measurements neither quantified microtube cooling rates nor isolated post-exit cooling. Across three EBSD maps of the same specimen per condition, AGC reduced the mean area-weighted grain diameter from 9.2 ± 0.2 µm to 5.1 ± 0.1 µm (mean ± SD of map-level values), a reduction of approximately 44%. The area fraction of high grain orientation spread (GOS ≥ 1°) increased from 4.7 ± 2.1% to 10.0 ± 0.8%. Both conditions retained a dominant extrusion-related texture, with similar mean Schmid factors for basal and prismatic 〈a〉 slip. AGC increased the tensile yield strength from 197 ± 1 MPa to 227 ± 1 MPa and the ultimate tensile strength from 243 ± 3 MPa to 265 ± 1 MPa. Elongation was 8.7 ± 1.2% for NC and 8.5 ± 0.8% for AGC; ductility equivalence was not established with three specimens per condition. Work-hardening analysis using effective true stress suggested a higher initial flow stress in AGC without enhanced post-yield hardening. Seven-day hydrogen-evolution and mass-loss measurements did not resolve a difference between NC and AGC (n = 3 per condition), and the electrochemical responses showed no persistent separation. AGC was associated with a finer as-extruded microstructure and higher axial tensile strength, while the short-term degradation behavior did not establish equivalence between conditions.
Source: Journal of Magnesium and Alloys
Institutions: Korea Institute of Materials Science, Korea University
Language: English
Subfield: Biomaterials
Field: Materials Science
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $1,500
Award: G5238761843
OpenAlex ID: W7235371037
