Work

Experimental assessment of active and passive cooling configurations for photovoltaic modules under outdoor conditions

Year: 2026
Type: article
Abstract: This study experimentally evaluated front-surface water-film cooling and rear-mounted aluminum heat sinks for polycrystalline photovoltaic modules under outdoor conditions. Two 100-Wp modules of the same model were monitored from November 2025 to March 2026, with temperature, voltage, and current recorded at 1-min intervals. During the representative active test, the maximum backsheet temperature was 42.0 °C for the water-film configuration and 50.5 °C for the reference module, a difference of 8.5 °C. Across nine monitoring days, differences between their daily maximum temperatures ranged from 8.5 °C to 18.96 °C. After subtracting 22.89 Wh of pump consumption, excluding power-supply losses and control-system consumption, the active configuration delivered 475.05 Wh of net electrical energy, compared with 438.06 Wh for the reference, corresponding to a difference of 8.44%. During the representative passive test, the heat-sink configuration showed a maximum backsheet temperature 1.50 °C below the reference and a daily electrical-energy difference of 1.70%, smaller than its reported expanded uncertainty. The investigated module operated with maximum power point tracking, while the reference used a fixed resistive load. Consequently, the electrical differences reflect both cooling and electrical load management and cannot be attributed exclusively to cooling. The water-film configuration showed a larger temperature reduction under its test conditions, but the active and passive results were obtained on different days and do not establish a comparison under matched environmental conditions.
Language: English
Field: Energy
Open Access status: gold
Estimated APC paid: $1,418
OpenAlex ID: W7235434849
FWCI:
Cites: 21
Cited by:
Related to: 10