Work

Effect of Liquid Metal Velocity during Low-Pressure Casting on the Microstructure and Mechanical Properties of Al12Si Alloy

Year: 2026
Type: preprint
Abstract: In this study, low-pressure die casting (LPDC) of the Al12Si (LM6) alloy was experimentally fabricated. For the Al12Si alloy, the velocity of the liquid metal in the gate cross sectional area was selected as 0.25, 0.50, and 1.00 m/s. To ensure the liquid metal's velocity, the metal was injected into the mould cavity using the required Argon gas, in accordance with Bernoulli's principle. Microstructural investigations and mechanical properties of an Al12Si alloy at different liquid metal velocities were evaluated. Microstructural analyses were performed using optical microscopy (OM) and scanning electron microscopy (SEM). Tensile and hardness tests were applied as mechanical tests. In microstructural examinations, it was determined that Al dendrites morphologically changed from linear-colonial to star-shaped as the liquid metal velocity increased. In addition, it has been determined that, during the solidification process under pressure, the liquid metal velocity and the Al-Si eutectic yield finer grains and a decrease in porosity. According to the density test results, the highest density was 2,465 g/cm³ at a liquid metal velocity at the gate of 0.5 m/s, and the lowest was 2,324 g/cm³ at a liquid metal velocity at the gate of 0.25 m/s. The change in hardness values could not be determined. According to the average tensile test results, the highest tensile strength was obtained at a liquid metal velocity at the gate of 0.5 m/s, 143 MPa (4.47% elongation), and the lowest tensile strength was obtained at a liquid metal velocity at the gate of 0.25 m/s, 125 MPa (3.48% elongation).
Language: English
Open Access status: green
OpenAlex ID: W7235685648
Cites: 29
Cited by:
Related to: 10