Evaluation of Barbed Suture in Side-to-Side Tendon Transfer Technique Using a Cadaveric Model
Year: 2026
Type: article
Abstract: BACKGROUND: To evaluate the biomechanical performance and efficiency of a barbed, knotless side-to-side (STS) tenorrhaphy versus a traditional running cross-stitch STS repair in a cadaveric tendon transfer model. METHODS: Flexor digitorum superficialis and profundus tendons (index, middle, and ring) from 5 fresh-frozen male cadaveric forearms (mean age 52.2 years) were harvested and randomized into 2 groups (n = 12/group). Each pair underwent a 3-cm overlap STS tenorrhaphy with either cross-stitch with a 3-0 braided polyester (Ethibond) or barbed running grasping repair with 2-0 barbed monofilament PDS (Stratafix). After 200 preconditioning cycles at 0.5 Hz to 10% strain (≤30 N), constructs were pulled to failure at 1 mm/s. Primary outcomes were ultimate load and stiffness; secondary outcomes included force reduction after cyclic loading and operative time. RESULTS: < .0006). Displacement at failure was similar (~19-20 mm). Force reduction with cyclic loading did not differ (39% ± 11% vs 34% ± 16%). Barbed repair time was 27.2% shorter (199 vs 272 seconds). CONCLUSION: Both STS techniques demonstrated ultimate loads substantially greater than the 15 to 35 N forces reported during passive motion and early active postoperative flexor tendon rehabilitation protocols; however, barbed constructs were approximately 33% weaker and less stiff than cross-stitch repair despite reduced operative time. Although barbed STS repair may have utility in select situations, running cross-stitch repair remains the biomechanical benchmark, and further optimization and clinical validation of barbed constructs are needed before broader adoption.
Source: Hand
Institution: Medical College of Wisconsin
Language: English
Subfield: Surgery
Field: Medicine
Domain: Health Sciences
Open Access status: bronze
OpenAlex ID: W7235850493
