Work

Parametric Study of Scarf Adhesive Joints Under Tensile Loading a Comparative Study of Analytical, Experimental and Finite Element Results

Year: 2026
Type: article
Abstract: Adhesive bonding is a promising alternative to mechanically fastened joints since it allows for load transfer over a continuous interface and eliminates holes which can act as stress raisers. In the present work, a scarf bonded joint is studied under static tensile loading. The parameters investigated are the scarf angle, adhesive layer thickness and resin to hardener mixture ratio. Stainless-steel adherends and an epoxy adhesive were used in the source study. The source study combined a Taguchi L9 experimental design with finite element analysis (FEA) and compared numerical predictions with experimental results. The maximum response reported was 2.3808 N/mm2 for a 60° scarf angle, 1 mm adhesive layer and 1:1 mixture ratio. For a representative comparison, the report gives equivalent stress values of 40.86 MPa by mathematical calculation and 42.372 MPa by FEA for a riveted joint, compared with 2.29 MPa analytically, 2.38 MPa by FEA and 2.34 MPa experimentally for the adhesive joint. These values show a much lower recorded stress response of the investigated bonded configuration. However, the dataset is limited to a small number of factor combinations, and the response wording and units reported need to be clarified prior to publication. The paper therefore presents the results as a preliminary parametric investigation and not as a general design rule.
Language: English
Open Access status: green
OpenAlex ID: W7235940312
FWCI:
Cites:
Cited by:
Related to: 10