Year: 2026
Type: article
Abstract: The wheel hub connects the wheel and brake disc to the suspension of a vehicle. It is mounted on the wheel bearing, carries the wheel studs on its flange and transmits the weight of the vehicle, the cornering forces and the braking torque from the wheel to the knuckle. Because the hub rotates with the wheel, it is subjected to a load that changes direction once in every revolution, and a crack in its flange or spindle can cause the wheel to separate from the vehicle. The hub is also part of the unsprung and rotating mass, so a lighter hub improves ride, handling, acceleration and braking response. This paper presents the design and analysis of a front wheel hub for a compact passenger car with a gross mass of 1,250 kg. The hub, with a four-stud flange on a pitch circle diameter of 100 mm and an integral bearing seat, was modelled in CATIA and analysed in ANSYS Workbench. The governing load case combined a vertical bump load of 9.2 kN, a lateral cornering load of 4.4 kN and a braking torque of 1,150 N m. Static structural, modal, steady-state thermal with coupled thermal-structural, and fatigue analyses were carried out to evaluate strength, stiffness, vibration behaviour, the effect of brake heat and service life. Four materials were compared on the same geometry, mesh and loads: grey cast iron, structural steel, aluminium alloy 6061-T6 and aluminium alloy 7075-T6. The maximum von Mises stress was between 98.6 and 101.3 MPa for all materials and appeared at the fillet between the flange and the hub barrel close to the stud holes. The factor of safety was 2.64 for grey cast iron on its ultimate strength, 2.47 for structural steel, 2.78 for aluminium 6061-T6 and 5.04 for aluminium 7075-T6. The hub mass was 2.86 kg in cast iron, 3.12 kg in steel, 1.07 kg in 6061-T6 and 1.12 kg in 7075-T6. The thermal analysis, with the brake disc mounting face held at 180 degrees Celsius, gave a peak hub temperature of 142 degrees Celsius at the flange and 68 degrees Celsius at the bearing seat. When this temperature field was combined with the mechanical loads, the stress in the 7075-T6 hub rose to 128.5 MPa while its yield strength fell to about 440 MPa, giving a factor of safety of 3.42. The 6061-T6 hub dropped to a factor of 1.91 and did not reach the fatigue target of one million cycles. Forged aluminium 7075-T6 was therefore selected, giving a mass reduction of 60.8 percent compared with the cast iron hub and a first natural frequency of 1,634 Hz. The study shows that a finite element based design workflow can compare materials, account for the heat flowing from the brake into the hub and identify critical regions such as the flange fillet and stud bosses before any casting or forging is made. The procedure reduces dependence on prototype testing, supports a well reasoned choice of material and gives a substantial reduction in rotating mass. It can be extended to rear hubs, hub-bearing units and wheel carriers in future work.
DOI: 10.64751/1brf0v49
Language: English
Topic: Engineering Applied Research
Subfield: Civil and Structural Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: hybrid
OpenAlex ID: W7235948313
