Mechanical Properties and Impact-Sliding Wear of AISI 1020 Steel after Electrochemical Boriding and Subsequent Heat Treatment
Year: 2026
Type: article
Abstract: AISI 1020 steel is widely used in engineering applications owing to its low cost and good formability; however, its relatively low surface hardness limits its wear resistance under severe contact conditions. This study investigated the mechanical and tribological response of AISI 1020 steel subjected to a hybrid treatment combining electrochemical boriding with subsequent thermal treatment and water quenching. Electrochemical boriding was performed at 950 °C under a current density of 200 mA cm-2 for 15 min. After the electrical current was interrupted, the specimens were cooled in the molten electrolyte to a furnace-indicated temperature of 725 °C, held for 30 min, and quenched in water. Cross-sectional microscopy revealed a predominantly light-contrast boride layer approximately 50 μm thick. X-ray diffraction identified Fe2B reflections without distinct detectable FeB reflections, supporting the formation of an Fe2B-dominant layer. The treated surface exhibited a hardness of 1744 ± 100 HV0.05. Ultimate tensile strength increased from 738 to 832 MPa, whereas total elongation decreased from 22.8% to 10.8%. Under the investigated impact-sliding conditions, wear volume per cycle decreased by approximately 11% in the impact-dominated region and 16% in the sliding-dominated region relative to untreated steel. Localized cracking was nevertheless observed in the treated surface after impact loading. These findings demonstrate that the combined treatment reduced wear under the tested conditions while introducing a trade-off between increased ultimate tensile strength and reduced tensile ductility.
Authors: Harun Mindivan, Eda Tuzcu Şahin
Institution: Bilecik Şeyh Edebali Üniversitesi
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7235964868
