Lightweight Aircraft Battery Enclosures Made From 3-D Printed Continuous Fiber-Reinforced Composites
Year: 2026
Type: article
Abstract: Advanced electric and hybrid-electric aircraft require battery enclosures that are both lightweight and structurally reliable. Continuous fiber-reinforced composites produced via additive manufacturing (AM) offer an effective solution by enabling tailored fiber architectures and reduced mass compared to traditional metallic housings. Continuous fiberglass reinforced (CFGR) composites were fabricated using fused filament fabrication and evaluated under tension, compression, and flexural loading to quantify mechanical performance. A full-scale, 12-inch-long battery enclosure was simulated, optimized, fabricated, and subjected to 100 h of cyclic cantilever bending to assess durability under representative service conditions. Results indicate that fiber orientation and architecture strongly influence mechanical response, with on-edge and concentric configurations exhibiting the highest strength and stiffness. The enclosure sustained repeated deflections of up to 7.65 mm without permanent deformation or cracking, confirming its suitability for installation in aircraft wing structures. These findings demonstrate the potential of continuous fiber AM to produce lightweight, structurally robust battery enclosures and establish a framework for integrating simulation-guided design with mechanical testing.
Source: Batteries
Authors: Meelad Ranaiefar(Conceptualization, Formal analysis, Investigation, Methodology, Software, Writing – original draft, Writing – review & editing), Amjad Almansour(Conceptualization, Formal analysis, Funding acquisition, Investigation, Supervision, Writing – review & editing), Mrityunjay Singh(Conceptualization, Funding acquisition, Supervision, Writing – review & editing)
Institutions: Glenn Research Center, Ohio Aerospace Institute
Language: English
Subfield: Industrial and Manufacturing Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $3,258
OpenAlex ID: W7236353337
