Parametric design selection and ambient experimental assessment of a beryllium-copper spiral flexure spring for long-life Stirling cryocooler compressors
Year: 2026
Type: article
Abstract: Free-piston Stirling cryocoolers require flexure suspensions that combine low axial stiffness, high radial stiffness, modal separation, manufacturability and long cyclic endurance. This study reports a constrained, one-factor-at-a-time parametric screening procedure for a three-arm spiral flexure disc, followed by ambient experimental assessment of the selected design. Six candidate alloys (AISI 302, AISI 304, Be-Cu C17000, Be-Cu C17200 TH, Ti-6Al-4V and AMPCOLOY® 944) and five geometric variables (arm count, spiral-cut width, sweep angle, disc thickness and disc diameter) were screened using nonlinear static structural, modal and stress-life finite element analyses in ANSYS® Workbench, with photo-etch manufacturability treated as a hard feasibility constraint. The selected configuration was Be-Cu C17200 TH, three arms, 0.6 mm cut width, 0.7 mm disc thickness, 560° sweep, 69 mm diameter and ±5 mm design stroke. For the selected design, analytical, numerical and experimental axial stiffness values were 1495.00, 1451.45 and 1460.25 N/m, respectively; the three routes agreed within 3%, while FEA and experiment differed by 0.6%. Measured and predicted strain agreed within 3%–7% across the stroke. An ambient fatigue campaign reached 100,755,000 fully reversed cycles at ±5 mm and 50 Hz without detected crack initiation, exceeding the adopted 10 8 -cycle run-out criterion by 0.76%. This result is a run-out at one stress level rather than a statistical infinite-life demonstration. Cryogenic mechanical qualification, direct radial-stiffness measurement, and a formal global multi-objective optimisation remain outside the present evidence base.
Authors: Virendra Bhojwani(Conceptualization, Investigation, Supervision, Writing – original draft, Writing – review & editing), Suraj Bhoyar(Data curation, Methodology, Writing – original draft), Rakesh Sidheshware(Formal analysis, Validation, Writing – review & editing), Pralhad Tipole(Data curation, Formal analysis, Investigation, Writing – original draft), Sunil Kulkarni(Investigation, Project administration, Writing – review & editing)
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $1,418
OpenAlex ID: W7236601896
