Work

Start-Capacitor Switching and Supply-Frequency Selection in an Inverter-Fed Capacitor-Start Capacitor-Run Single-Phase Induction Motor Drive

Year: 2026
Type: article
Abstract: Inverter-fed capacitor-start capacitor-run (CSCR) single-phase induction motors often run at reduced speed, yet start-capacitor switching and supply-frequency selection are rarely studied together. This simulation study examines a 1.2 kVA CSCR motor fed by a unipolar sinusoidal pulse-width-modulated full-bridge inverter with an LC filter and controlled by a proportional-integral (PI) speed loop, optional cascaded voltage and inductor-current PI loops, and look-up-table (LUT) frequency selection. At 3 N·m, the fixed 1125 rpm threshold leaves the start capacitor connected at 800–1000 rpm, raising the input power to 723–1244 W and the auxiliary-winding copper loss to 7–13 times its 50 Hz value. Frequency-dependent or time-delayed disconnection reduces the input power by 44–65% (still at least 32% with realistic capacitor resistances or ±20% motor-parameter changes). A power balance shows that a simple loss model captures only 18–31% of the motor losses in this state. With the capacitor disconnected, the LUT, a model-based frequency assignment, and perturb-and-observe searches yield input powers within 1% of one another and 6.6–10.1% below constant volts-per-hertz control at 3 N·m. The inner PI loops lower the voltage total harmonic distortion 2.7–7.0 times without changing the estimated losses. Capacitor switching and frequency selection should thus be designed together.
Source: Electronics
Language: English
Open Access status: gold
Estimated APC paid: $2,896
OpenAlex ID: W7236644155
FWCI:
Cites: 52
Cited by:
Related to: 10