Research into the method of selective electric-arc additive melting of samples made from powders of austenitic stainless steel AISI 316L
Year: 2026
Type: article
Abstract: Purpose ‒ to identify the range of permissible values for technological parameters (welding current, inter-electrode gap, and layer thickness) when forming samples from austenitic stainless steel powder AISI 316L, as well as at subsequently studying their microstructure and porosity. Methods. Experimental samples were manufactured on a modernized laboratory bench with CNC and a PROFI TIG 315 P AC/DC welding source in an argon environment. The construction material used was AISI 316L powder with a particle size of 150–350 µm, applied to a substrate made of 03Kh17N14M3 steel. To determine the permissible modes, a visual criterion for assessing the continuity and geometry of the rolls was used. Metallographic analysis and porosity determination were carried out using an Altami MET 1S microscope with Thixomet software using the linear method. The preparation of the sections and etching were carried out using a solution of CuSO4, H2SO4, and HCl. Results. As a result of the research, the technological limitations of the selective electric‑arc additive melting process for samples made of austenitic stainless steel powders have been established: the minimum flow rate of the shielding gas must not be less than 5 L/min, the minimum welding current is 90 A, the minimum layer thickness is 1 mm, and the inter-electrode gap must not exceed 2 mm. Based on the obtained data, the range of permissible mode values has been constructed. Metallographic examination of the sample, showed that the maximum grain size in the structure is 0.39 mm, which corresponds to the level of cast steels, and the porosity does not exceed 0.3%. Conclusion . The range of permissible values for the parameters of the selective electric-arc melting of samples made from powder of austenitic stainless steel AISI 316L has been determined specifically, the deposition current and the layer thickness. The results of metallographic examination show that the sample obtained by selective electric-arc melting of powder has an average grain size typical of steels produced using casting technology, and the porosity does not exceed the maximum porosity established for samples.
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: hybrid
OpenAlex ID: W7236668666
