Work

Nanofluids for Compact Heat Exchangers

Year: 2026
Type: article
Abstract: Nanofluids, colloidal suspensions of particles smaller than 100 nm in a base liquid, are widely studied as advanced coolants because even small particle loadings can raise thermal conductivity above that of the base fluid. The benefit, however, is partly offset by higher viscosity and density, so a fair assessment must couple thermophysical properties with flow-side penalties. This paper presents a model-based comparison of four water-based nanofluids (Al₂O₃, CuO, TiO₂, ZnO) at volume fractions of 0 to 4% in turbulent pipe flow. Conductivity is evaluated with the Maxwell model, viscosity with the Brinkman model, and density and specific heat with mixture rules. Heat-transfer coefficients follow the Dittus–Boelter correlation at a fixed Reynolds number of 10,000, and pumping power follows the Blasius friction factor. Conductivity increases monotonically with loading, and Al₂O₃ gives the highest effective conductivity ratio, but the highest heat-transfer coefficient gain at 4% is only 6.1% (Al₂O₃) because the Prandtl number falls as viscosity rises. When pumping power is included through a figure of merit, CuO at 4% performs best (1.114) and Al₂O₃ falls below unity (0.978). The study shows that conductivity ranking alone is a poor guide to coolant selection.
Language: English
Open Access status: green
OpenAlex ID: W7236734319
FWCI:
Cites:
Cited by:
Related to: 10