Work

Electrical Response of PVDF Piezoelectric Sensors to Controlled Low-Energy Impacts: Influence of Geometry and Mounting Conditions

Year: 2026
Type: article
Abstract: Contact-based impact sensing is a candidate alternative to optical seed monitoring near the seed-tube outlet, where dust contamination limits optical sensors. This laboratory study quantifies how the geometry and mounting conditions of polyvinylidene fluoride (PVDF) film sensors influence two design metrics of their electrical response to repeatable controlled low-energy impacts: the peak-to-peak voltage, Upp, which governs detection-threshold robustness, and the ring-down duration, td, which limits event separability. Impacts were generated with a patented spring-driven test stand; a separate high-speed-video validation at four spring settings showed that the pre-impact kinetic energy of the impactor was repeatable to within approximately 5% (relative standard deviation). Five commercial PVDF sensors were first compared in a beam configuration (Stage I); two of them were then tested in 21 and 5 mounting variants, respectively (Stage II); and three selected configurations were characterised over nominal impact energies of 0.64–25.5 mJ (Stage III). For a single sensor, the mounting alone changed Upp from 2.6 to 22 V and td from 2.2 to 360 ms, and a foam damper shortened td by a factor of 1.6–25. In Stage III, the dependence of Upp on the nominal spring energy was described by a square-root model with an intercept (R2=0.975–0.981). The ring-down duration did not exceed 13.1 ms in the tested configurations, remaining below the assumed minimum inter-impact interval of 100 ms. Field performance, clogging detection and counting accuracy were not evaluated and are left for future work.
Source: Sensors
Language: English
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W7236789497
FWCI:
Cites:
Cited by:
Related to: 10