A Study of the Effect of Cutting Factors on the Metal Removal in Lathe Turning of AISI 1045 Steel
Year: 2026
Type: article
Abstract: The metal removal rate is considered one of the most important factors affecting productivity during the turning process; however, in many workshops, cutting parameters are still selected based on tables in the operating manual or based on the operator’s experience. This study examined the effects of spindle speed (262,412, and 600 rpm), depth of cut (0.9, 1.6, and 2.0 mm), and feed rate (0.15, 0.18, and 0.24 mm/rev) on the material removal rate of medium-carbon steel A1045 when turned on a conventional lathe using a carbide-tipped tool and cutting fluids. The Taguchi methodology was used to determine the number of experiments required and to analyze the signal-to-noise ratio (S/N) under the criterion “the higher the value, the better”. Nine experiments were conducted using the L9 orthogonal array, Experiment No. 3, which involved the following parameters (rotational speed 262 rpm, cutting depth 2 mm, feed rate 0.18 rev/min), which achieved the highest metal removal rate of 16.454 g/min, corresponding to the highest S/N ratio of 24.325. An ANOVA analysis was also carried out to determine the expected optimal operating parameters; the experiment with the following conditions (rotational speed 600 rpm, cutting depth 2 mm, feed rate 0.18 rev/min), which falls outside the nine experiments carried out and is expected to yield the highest S/N ratio of 24.766 and the highest MRR of 17.31 g/min, representing a 5.2 % increase on the optimum value previously obtained. As shown by the analysis of variance, cutting depth played the greatest role in increasing MRR, accounting for 95.7%, whilst cutting speed accounted for 0.6% and the feed rate for 0.62%. A multiple linear regression model was also developed with a statistical significance of 94.85% (R =, P < 0.001), where the predictive value showed a high degree of agreement with the experimental results; it can therefore be used to estimate (MRR) within the ranges studied.
Source: مجلة روافد المعرفة
Institution: Azzaytuna University
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W7236871353
