From cryogenic ball milling to aqueous dispersion: preparation of fragment-like polyethylene and polystyrene microplastic test materials
Year: 2026
Type: article
Abstract: Preparation of reproducible microplastic (MP) test materials remains a key challenge in fate, toxicity, and removal studies. This study developed a facile cryogenic ball-milling and surfactant-assisted dispersion workflow to produce fragment-like polyethylene (PE) and polystyrene (PS) MP test materials. Milling was optimised by varying feed mass, milling time, bead size, bead number, and cycle configuration. The lowest PS Dv 90 was 244 µm, achieved using 1-g feed, single 25-mm bead and 5 min of milling time. Optimised conditions for PE (0.25 g of feed with five 10-mm beads milled for 15 min) reduced Dv 90 from 235 to 59 µm. MPs produced under the respective optimised milling conditions were tested in 0.02% (w/v) aqueous solutions of Tween 80, Triton X-405, polyvinyl alcohol (PVA) and polyethylene glycol (PEG). Suspension behaviour was assessed by 24-h visual observation and 2-h turbidity measurements, supported by contact-angle and FTIR analyses. Among the tested surfactants, Tween 80 produced the most effective dispersion and reduced the contact angles from 115° to 84° (PE) and 88° to 57° (PS). Under static conditions, visible suspension persisted for at least 24 h for PE and more than 3 h for PS. The observed behaviour is consistent with improved interfacial wetting and possible steric stabilisation at the MP-water interface. FTIR spectra of the recovered, rinsed MPs retained the characteristic polymer bands, with no detectable chemical modification. These findings guide the selection of milling conditions and dispersing agents for preparing fragment-like MP suspensions for laboratory studies.
Institution: UNSW Sydney
Language: English
Subfield: Pollution
Field: Environmental Science
Domain: Physical Sciences
Open Access status: hybrid
Estimated APC paid: $2,790
OpenAlex ID: W7237345287
