Get started
Author

J. Gil Sevillano

Observed names: Gil Sevillano, Javier, J GILSEVILLANO, J Gil Sevillano, J. G. SEVILLANO, J. GIL SEVILLANO, J. GIL-SEVILLANO, J. Gil-Sevillano, J. Gil Sevillano, J.G. SEVILLANO, J.G. Sevillano, J.GIL SEVILLANO, J.Gil Sevillano, Javier Gil Sevillano, Javier Gil-Sevillano, Javier Sevillano
Observed institutions: Intel (United States), Consejo Superior de Investigaciones Científicas, University of the Basque Country, Centro de Estudios e Investigaciones Técnicas de Gipuzkoa, Instituto de Cerámica y Vidrio, Forgital (Italy), Universidad de Navarra, Bekaert (Belgium), KU Leuven
ORCID: 0000-0002-1716-8200
Observed ORCID: 0000-0002-1716-8200
OpenAlex ID: A5086910399
Large strain work hardening and textures
1980 · J. Gil Sevillano, P. van Houtte, et al. · Progress in Materials Science · 824
An alternative model for the strain hardening of FCC alloys that twin, validated for twinning-induced plasticity steel
2008 · J GILSEVILLANO · Scripta Materialia · 190
Absence of one-to-one correspondence between elastoplastic properties and sharp-indentation load–penetration data
2005 · J. Alkorta, J.M. Martínez-Esnaola, et al. · Journal of materials research/Pratt's guide to venture capital sources · 138
Cross-sectional nanoindentation: a new technique for thin film interfacial adhesion characterization
1999 · J.M. Sánchez, S. El-Mansy, et al. · Acta Materialia · 137
Critical examination of strain-rate sensitivity measurement by nanoindentation methods: Application to severely deformed niobium
2007 · Jon Alkorta, José Manuel Martínez-Esnaola, et al. · Acta Materialia · 125
Modelling cleavage fracture of bainitic steels
1994 · A. Martín-Meizoso, I. Ocaña-Arizcorreta, et al. · Acta Metallurgica et Materialia · 103
Residual stress profiling in the ferrite and cementite phases of cold-drawn steel rods by synchrotron X-ray and neutron diffraction
2004 · M.L. Martinez-Perez, F.J. Mompean, et al. · Acta Materialia · 101
A comparison of FEM and upper-bound type analysis of equal-channel angular pressing (ECAP)
2003 · Jon Alkorta, Javier Gil Sevillano · Journal of Materials Processing Technology · 97
Low energy dislocation structures in highly deformed materials
1987 · J. Gil Sevillano, E. Aernoudt · Materials Science and Engineering · 92
Electro-discharge machining (EDM) versus hard turning and grinding—Comparison of residual stresses and surface integrity generated in AISI O1 tool steel
2007 · V. García Navas, I. Ferreres, et al. · Journal of Materials Processing Technology · 89
Intrinsic size effects in plasticity by dislocation glide
2001 · J Gil Sevillano, I Ocaña Arizcorreta, et al. · Materials Science and Engineering A · 88
Room temperature plastic deformation of pearlitic cementite
1975 · J.Gil Sevillano · Materials Science and Engineering · 86
Ductilization of nanocrystalline materials for structural applications
2004 · J Gil Sevillano, J Aldazabal · Scripta Materialia · 80
Hall-Petch Relationship of a TWIP Steel
2009 · F. de las Cuevas, Mónica Reis, et al. · Key engineering materials · 78
Two-dimensional sections of the yield locus of a Ti6%Al4%V alloy with a strong transverse-type crystallographic α-texture
1995 · J.A. Medina Perilla, J. Gil Sevillano · Materials Science and Engineering A · 74
Preface to the viewpoint set on: geometrically necessary dislocations and size dependent plasticity
2002 · A Needleman, J.Gil Sevillano · Scripta Materialia · 70
The contribution of macroscopic shear bands to the rolling texture of FCC metals
1977 · J. Gil Sevillano, P. Van Houtte, et al. · Scripta Metallurgica · 70
Rapid Transformation Annealing: a Novel Method for Grain Refinement of Cold-Rolled Low-Carbon Steels
2007 · C. Lesch, P. Álvarez, et al. · Metallurgical and Materials Transactions A · 69
Fatigue Behavior of Four High-Mn Twinning Induced Plasticity Effect Steels
2010 · A.S. Hamada, L.P. Karjalainen, et al. · Metallurgical and Materials Transactions A · 62
Flow Stress and Work Hardening
2006 · Javier Gil Sevillano · Materials Science and Technology · 53
The fractal nature of gliding dislocation lines
1991 · J.Gil Sevillano, E. Bouchaud, et al. · Scripta Metallurgica et Materialia · 53
A quantitative assessment of forest-hardening in f.c.c. metals
1987 · F.Hernández Olivares, J. Gil Sevillano · Acta Metallurgica · 50
Substructure and strengthening of heavily deformed single and two-phase metallic materials
1991 · J. Gil Sevillano · Journal de Physique III · 49
Internal stresses and the mechanism of work hardening in twinning-induced plasticity steels
2012 · Javier Gil Sevillano, Fernando de las Cuevas · Scripta Materialia · 47
Geometrically necessary twins and their associated size effects
2008 · Javier Gil Sevillano · Scripta Materialia · 45
Works count: 177
Citation count: 4,052
H-index: 31
I10-index: 71
Year
Topic
Type