Author

H. Cho

Institution: The University of Kitakyushu

Observed institution: The University of Kitakyushu

OpenAlex ID: A5110148013

The Fabrication and Output Power Characteristics of a Heat-Engine using a Shape Memory Alloy Spiral Spring Actuator

2013 · H. Cho, M. Senju, et al. · Transactions of the Materials Research Society of Japan · 7

Effects of the Volume Fraction of Martensitic-phase during Buckling Deformation on Post-buckling Behavior of Tape-shaped Ti-Ni Shape Memory Alloy Element

2021 · Y. Doi, T. Ishii, et al. · Transactions of the Materials Research Society of Japan · 5

Fabrication and Output Characteristics of a Belt-Driven Type Heat-Engine Using Shape Memory Alloy Spiral Spring Actuators

2015 · T. Morita, Y. Nishimura, et al. · Transactions of the Materials Research Society of Japan · 4

Effects of Heat-treatment Temperature on Shape Memory Characteristics of a Tape-shaped Ti-Ni Alloy Element Fabricated by a Centrifugal Casting Method

2017 · C. Nakagawa, H. Fujiki, et al. · Transactions of the Materials Research Society of Japan · 2

The Effect of Applied Strain during Repeated Heat-treatment under Constrained Strain on The Mechanical and Shape Memory Properties of Ti-Ni Shape Memory Alloy

2013 · H. Cho, D. Kotegawa, et al. · Transactions of the Materials Research Society of Japan · 1

The Effect of Constraint Conditions on the Bending Operating Characteristics of a Weft Yarn-type Shape Memory Alloy Actuator

2019 · K. Saka, H. Cho, et al. · Transactions of the Materials Research Society of Japan

Fabrication and Output Power Characteristics of a Pulley-type SMA Heat-engine Including the Idler Wheel with a Cooling System

2018 · T. Akagi, C. Nakagawa, et al. · Transactions of the Materials Research Society of Japan

Effects of Heating and Cooling Cycle on the Shape Memory and Mechanical Characteristics of Tape-shaped Shape Memory Alloy Element

2018 · C. Nakagawa, H. Cho · Transactions of the Materials Research Society of Japan

Effects of heating/cooling-water temperatures on output power characteristics of forced cooling pulley-type SMA heat-engine

2018 · T. Tsuda, C. Nakagawa, et al. · Transactions of the Materials Research Society of Japan

Effects of Surface Smoothness on the Fatigue Characteristics of Ti-50.4at%Ni Shape Memory Alloy Wire

2015 · S. Narumi, K. Takigawa, et al. · Transactions of the Materials Research Society of Japan

Works count: 10

Citation count: 19

H-index: 3

I10-index: