Preparation, Characterization and Machinability of Al7075-Al2O3 Matrix Composite Using Multi Layer Coated Carbide Insert
Year: 2014
Type: article
Abstract: This experimental study is done to investigate distribution of Al2O3 (15% wt) having particle size of 20 μm in Al-7075 (T6) matrix composite, fabricated by stir casting method and study influence of cutting parameters on surface finish using multi coated carbide inserts. Uniform distribution of Al2O3 particles was observed using microstructure study. The characterization of the prepared samples was carried out using X-ray diffraction and scanning electron microscopy. Machinability study was done on medium duty lathe using multi coated carbide insert. Taguchi L9 orthogonal array method is applied for designing an experiments with the selection of cutting parameter, cutting speed of 80,100,120m/min, feed rate of 0.103, 0.206, 0.296 mm/rev, and cutting depth of 0.3, 0.6, 0.9 mm. The optimal cutting conditions was found using the signal-to-noise (S/N) ratio for surface roughness parameters (Ra, Rt), cutting force, tool wear according to the “the-smaller-the-better” approach. Taguchi response analysis and ANOVA is used to optimize the parameters influencing the objectives. The optimum cutting levels for surface roughness at cutting speed of 80m/min, feed rate of 0.103 mm/rev and depth of cut at 0.3 mm, for tool flank wear cutting speed of 120m/min, feed rate of 0.296 mm/rev and depth of cut at 0.9 mm and for cutting force cutting speed of 120m/min, feed rate of 0.103 mm/rev and depth of cut at 0.3 mm.In order to achieve good surface finish and reduced tool wear, higher cutting speed and lower feed rate combination is suggested for machining Al-7075(T6) - Al2O3 matrix composite.
Source: Procedia Materials Science
Authors: K. Venkatesan, R. Ramanujam, Vignesh.V. Shanbhag, Nitin.N. Yalamoori, D.VenkataSubba Reddy
Institution: Vellore Institute of Technology University
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
OpenAlex ID: W1998266331
