Year: 2014
Type: article
Abstract: The emitter formation step (POCl3 diffusion) in p-type crystalline silicon solar cell processing includes many variables, e.g., peak temperature, gas flows, temperature ramps, which can be optimized in order to improve material quality. Diffusion parameters of an 80-Ω/L1 emitter are varied, and the resulting change in electronic quality of multicrystalline silicon is analyzed. A detailed gettering analysis of multicrystalline material, surface passivated with hydrogen-rich amorphous silicon, after POCl3diffusion, and an additional gettering step combined with hydrogenation from SiNx:H is presented. The industrial-type diffusion leads to material of lower electronic quality than the extended reference diffusion. A major finding of this paper is the fact that results on different 5 × 5 cm2samples out of one 15.6 × 15.6 cm2wafer can vary significantly. Hence, conclusions about which diffusion is most efficient in gettering strongly depend on wafer position. An edge position close to crucible walls, for example, might improve less effectively than another position close to the crucible center. In fact, the opposite can also be shown, and samples originating from edge regions reach their highest lifetimes after gettering. This is explained by the different defect structure of the investigated samples. Structures exhibiting high gettering efficacy contain fewer recombination active grain boundaries and are predominantly free of extended defect clusters.
Source: IEEE Journal of Photovoltaics
Authors: Sarah Gindner, Philipp Karzel, Bernhard Herzog, Giso Hahn
Institution: University of Konstanz
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2050449449
