Work

The influence of curing and surface preparation on the adhesion of protective coatings on concrete

Year: 2010
Type: dissertation
Abstract: In cases where concrete has to be repaired or protected due to exposure to an \naggressive environment, a protective coating is often used. The guidelines \nreferenced on the subject of repairs and coatings of concrete require the substrate \nmust be clean, dry and free from loose material but no mention is made of a \npreferred method of surface preparation. \nThis research report presents details of an investigation in which concrete was \nsubjected to different curing regimes in order to induce different qualities of surface \nconcrete. The different surface qualities were prepared using four alternative surface \npreparation methods prior to coating. After an initial investigation, five different \ncoatings were chosen in order to cover a broad spectrum of coatings available to the \nconstruction industry. \nOnce the applied coatings had cured they were tested using a pull-off testing device \nto determine the adhesion properties. The mode of failure was determined by visual \nexamination. In addition, surface characteristics were determined using an optical \nmicroscope and the water sorptivity test. \nResults indicate that preparing the surface before application of coatings does \nimprove adhesion. The preparation that was easiest to carry out, and which also \ngave the best adhesion results, was the wire brushing technique. Considering the \npracticality for site application, the mechanical method would be most appropriate. \nFrom the findings, aliphatic coating exhibited the best adhesion properties, while \nepoxy resin and cementitious-based materials also gave satisfactory results. \nB T Benn 7231599 iii \nElastomeric coating with lower adhesion strengths at early ages may be suited to \nsurfaces that are expected to crack, as the elastic nature of the material will bridge \nthe gap. Masonry paint, which was only used for comparative purpose did not \nperform as well as expected and had the lowest bond strengths. Where the removal \nof defective concrete is likely to result in a rough surface the cementitious material \nmay be preferable.
Author: Tom Benn
Language: English
Open Access status: green
OpenAlex ID: W2227240802
Cites: 17
Cited by: 2
Related to: 9