Positioning control of a pneumatically actuated stage -Control of reaction force and flow disturbance and improvement of positioning speed-
Year: 2015
Type: dissertation
Abstract: Positioning stages are widely applied in the precision technology, such as manufacturing process of semiconductor devices, scanning probe microscopy (SPM), and etc. Nowadays the manufacturing industries are trying to make the semiconductor conductor devices more compact, in order to reduce the cost.However, to meet these demands ultra-high precise stages with high speed and high resolution are required.These crucial demands inspired researchers to develop ultra-high precision stages.This is the main reason that the control of critical problems of positioning systems is interpreted by many researchers since last three decades.However, a few studies have concerned the effect of reaction force in linear motor driven positioning stages.While this problem along with positioning speed was still not concerned in a pneumatically actuated stages.Therefore, in our works, we focused on the positioning control of a pneumatic positioning stage.The concerned pneumatic stage is composed of the mechanical and pneumatic parts.The mechanical part consists of a single-axis moving stage which provides bidirectional motion towards x-axis, and placed between two parallel needle bearings guideways fixed on the top of a base plate.Whereas the base plate is suspended on four units of coil-type wafers (thin slices of the semiconductor materials, e.g., silicon) through the chemical and photolithographic processing.There are two main important factors in the semiconductor manufacturing, i.e., the number of components inside an IC chip and the lineweight/ spaceweight.Both of these factors have a significant effect on the cost of the IC chip.The cost per component is almost inversely proportional to the number of components in a simple circuit [5] .Therefore, large number of components and small lineweight in an IC package results in a major cost reduction.According to Mack [6][7] , the number of components in a chip is a highly crucial factor for reducing the cost of the IC chip.The number of components per chip is well-known as Moor's Law that was firstly defined for the number of resistors and capacitors per chip, and later was also used for the number of transistors per chip.Based on the Moor's prediction in 1965, the number of components in a chip that was increased from 1 component (first commercial planar transistor in 1959) had a growth of 65,000 components per chip at Intel in 1975 in which only 16,000 transistors were included [7] .Moor's original observation shows that the number of components in a chip doubles each year started from 1 component in 1959 [8] .Nawadays, millions of transistors can be placed in an IC chip with very small volume.The success behind this great improvement does not only belong to the development of the precision of electron beam lithography machines, but also belongs to the trends towards the development of ultra precise positioning stages with higher accuracy and resolution.In order to improve the accuracy and performance of positioning stages, their critical problems such as friction, internal/external disturbances, vibrations and etc. should be strictly controlled through advanced control systems. A Practical Look to the Positioning StagesIn this Section, the basic structure of positioning stages, the crucial role of the driving actuators and the types of positioning stages are discussed.Moreover, some common problems of positioning stages which are mostly concerned by many researchers are introduced.While the control strategies for the compensation of the mentioned problems will be reviewed in Chapter 2. 5 2
Author: Mohebullah Wali
Institution: Tokyo University of Agriculture and Technology
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W2255305136
