Influence of process parameters on deep drawing of 2060 Al–Li alloy under hot stamping process
Year: 2019
Type: article
Abstract: In this paper, the hot stamping formability of 2060 Al–Li alloy was studied by numerical simulation and experimental tests. The thickness of 2060 Al–Li alloy parts was analyzed when the deformation temperature is 400 °C, 450 °C and 480 °C, stamping speed is 15 mm/s, 25 mm/s and 35 mm/s. Simultaneously, the influence of lubrication on the thinning of 2060 Al–Li alloy cup-shaped parts is also analyzed. And Vickers hardness of the forming parts was tested after hot stamping tests. The results show that the deep drawing parts have good thickness uniformity at the deformation temperature ranging from 400 °C to 450 °C. However, the thickness of the cup parts is thinning seriously when the deformation temperature is 480 °C. With the increase of stamping speed, the thinning rate of cup-shaped parts decreases gradually. In this study, the thinning rate of the drawing parts is smaller when stamping speed is 35 mm/s. Compared with stamping parts without lubrication, cup parts with deeper depth can be obtained under better lubrication. With the improvement of lubrication conditions, the crack position of the formed part gradually shifts to the center of the cup. The simulation results and experimental results have good consistence.
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: diamond
Awards: G2603142613, G5393805456
OpenAlex ID: W2980717088
