Year: 1971
Type: dissertation
Abstract: Individual pulp fibers have been found to come under longitudinal tensile and compressive stresses in many commercial processes.It has been demonstrated.by other workers that drying pulp fibers under tensile loads increased.theYoung's modulus, tensile strength, rupture energy, and crystallite orientation of the fibers, and decreased their ultimate elongation.Little was known, however, about the effects which longitudinal compression had upon the mechanical properties of fibers.It was the purpose of this study to.observechanges which such compression caused and to examine alterations in fiber structure which accompanied these changes.Experimental work was carried outon springwood and summerwood fibers of a longleaf pine holocellulose pulp and with summerwood fibers of a longleaf pine kraft pulp.Drying these fibers under longitudinal compression resulted.inlarge decreases in tensile strength, initial modulus and crystallite orientation and increases in ultimate elongation and rupture energy.The strength losses.were found to be permanent and could not be recovered by rewetting the fibers.Rewetting caused large decreases in the elongation properties of springwood, and smaller:decreases in summerwood.Load-elongation properties of the fibers were drastically altered by drying under longitudinal compression.Load-unload cycling showed that these fibers were very inelastic, demonstrating a large secondary creep effect.Large increases in initial modulus were observed for each successive loadunload cycle of compressed fibers.This effect-was also observed in the concave upward appearance of the load-elongation curves for the longitudinally compressed fibers.material of the fiber becomes-partially or completely disoriented during longitudinal compression.It is likely that the effects outlined in this study are a significant factor in causing different paper mechanical properties to be observed in the cross-machine direction from those in the machine direction.Similarly, the implications of this study are ofpractical importance-to any sheet in which fiber strength is a limiting factor.In the case of the so-called extensible papers, these effects are undoubtedly of predominating importance.of the cross-sectional areas of these levels of organization.In Table I, results of the type presented by Frey-Wyssling are shown, but they have been slightly modified by the more recent work of Dolmetsch and Dolmetsch (22).It must be emphasized that such values are only useful for order-of-magnitude comparisons of the levels of structural organization.There does not appear to be any common structural element which is well defined and uniform in size for any of the cellulosic materials studied.TABLE I LATERAL DIMENSIONS OF FIBRILLAR ELEMENTS Area of Number of Cellulose Cross Section Chains in Cross Section Tracheid.350 pm. 2 1,000,000,000 Macrofibril (0.2 pm.) 2 = 0.04 pm.2 125,000 Microfibril (250 A.) 2 = 62,500 A. 2 2,000 Elementary fibril (30 A. x 40 A.) = 1200 A. 2 40 Cellulose molecule (4 A. x 8 A.) = 32 A. 2 1The fibrillar material is further organized into four distinctly different concentric layers which make up the cell wall.These layers are shown in Fig. 2 and consist of (1) the primary wall or P layer, (2) the outer secondary wall or S 1 layer, (3) the middle secondary wall, the S 2 layer, and (4) the inner secondary wall or S3 layer.Chemical and mechanical treatment of the fiber can break down each of these layers into additional readily distinguishable lamellae (23,24).
Author: David Paul Dumbleton
Language: English
Subfield: Industrial and Manufacturing Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
OpenAlex ID: W32934699
