Effect of Strip Width on Strip Shape in Ultra-Wide-Strip Tandem Cold Mill
Year: 2026
Type: article
Abstract: The strip width in ultra-wide-strip tandem cold rolling changes not only the total rolling load, but also the transverse span over which the work roll (WR) is loaded. This study quantifies the isolated width effect on strip crown at 40 mm from the edge (C40), flatness and WR elastic deformation in a 2180 mm CVC-6 tandem cold mill. A three-dimensional multi-stand elastic–plastic finite element (EPFE) model was established for five representative widths of 900, 1200, 1500, 1800 and 2100 mm, corresponding to contact-span ratios of 0.413–0.963. The results show that the strip width increased from 900 mm to 2100 mm, C40 decreased from 20~80 μm to −50~−280 μm, and 1800 mm was the transition point from the positive crown to the negative crown. At the same time, the quadratic flatness component increased toward a center-wave mode, whereas the quartic component decreased toward an edge–center coupled-wave mode. Mechanistically, the relative WR axis deflection at the strip edge increased much faster than the local WR flattening compensation, producing an edge-open loaded roll gap. The findings indicate that strip width should be treated as an independent preset variable for WR bending, intermediate-roll bending and intermediate-roll shifting in ultra-wide cold rolling.
Source: Metals
DOI: 10.3390/met16090981
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: gold
Estimated APC paid: $3,137
OpenAlex ID: W7207716645