Work

Synthesis of a Phosphoramidite Building Block for a Quinine-Based Fluorescence Resonance Energy Transfer Aptasensor

Year: 2026
Type: dissertation
Abstract: Nucleic acid aptamers are oligonucleotide sequences that can bind to small molecules with high affinity and selectivity through molecular recognition and sequence-dependent folding. Therefore, aptamers have been used as biosensors and analytical detection tools. Fluorescence-based aptasensors are able to provide real-time signal transduction due to their high sensitivity. In fluorescence resonance energy transfer-based aptasensors, fluorescence switching occurs due to the structural or chemical changes in the aptamer upon the interaction between a fluorophore and a quencher. Previous studies have shown that quinine promotes cleavage of an N–O bond when the T19 residue of the MN4 aptamer is replaced with an N–O-containing modified residue. This reaction provides a basis for developing a cleavage-responsive aptasensor in which N–O bond cleavage releases a quencher-bearing linker from the modified aptamer and restores fluorescence from an adjacent fluorescent nucleoside analogue. The purpose of this study was to synthesise and characterise a linker-bearing MABT phosphoramidite building block containing an N–O-linked 2-(2-aminoethoxy)ethyl chain for quencher attachment and incorporation into the MN4 aptamer. Three protecting-group strategies were investigated using N-trifluoroacetyl and Fmoc protection. Reaction progress was monitored by thin-layer chromatography, and the prepared intermediates and reaction mixtures were characterised using NMR spectroscopy and mass spectrometry. The N-trifluoroacetyl-protected route proceeded as intended through the reduction step, but difficulties were encountered during the subsequent acidic deprotection. Acidic deprotection produced a heterogeneous mixture containing the expected triol together with incompletely converted and de-trifluoroacetylated products. The Fmoc-protected route afforded the required aminooxy intermediate, but its condensation with the carbohydrate-derived dialdehyde produced a heterogeneous mixture from which the desired bis-oxime intermediate could not be isolated. Reanalysis of the aminooxy intermediate showed additional species consistent with formaldehyde- and acetaldehyde-derived oxime ethers, together with a possible de-Fmoc species. The final strategy involved removing the N-trifluoroacetyl groups after formation of the bis-oxime intermediate, followed by the introduction of Fmoc protection. This protecting-group exchange strategy enabled the isolation of the Fmoc-protected triol. Further cyclisation, DMTr protection and phosphitylation are required to produce the phosphoramidite building block before its incorporation into the MN4 aptamer and evaluation of the quinine-responsive fluorescence system.
Institution: University of Turku
Language: English
Open Access status: green
OpenAlex ID: W7220754353
Cites: 113
Cited by:
Related to: 10