Year: 2026
Type: article
Abstract: Embedded resistors can reduce component count, routing complexity, and assembly requirements in high density printed circuit boards (PCBs); however, conventional subtractive manufacturing of patterned resistive foils requires multiple steps and generates large amounts of hazardous waste and CO2 emissions. In this work, we investigate direct-write additive manufacturing of resistive films onto patterned copper terminations as a potential replacement for lithographically patterned foil resistors. Carbon-based resistive inks were deposited using a Voltera Nova dispensing platform and characterized to determine the effects of substrate fixturing, deposited geometry, process calibration, and copper–resistor interface resistance. Substrate fixturing was identified as a critical source of variability because the contact-based surface probing routine can deform thin PCB substrates and produce an inaccurate height map. Direct measurements on substrates confirmed that vacuum-bed fixturing limited out-of-plane displacement to 0.01 mm to 0.02 mm while corner clamping produced deformation of 0.72 mm. Replacing clamping with vacuum-bed fixturing reduced the maximum resistance variation from 150% to 6%. Variable length resistance calibration coupons were used to determine copper termination spacings for target values for 25, 50 and 100 Ω resistors. Results demonstrate batch resistance tolerances within ±5%, successfully remaining within the 20% tolerance threshold for foil resistors. Resistance vs. length measurements also indicated an apparent interface resistance contribution of approximately 4–8 Ω. Passivation of the copper surface with a layer of gold supported the hypothesis that the interface chemistry contributes to device resistance; however, the interface contribution is not sufficiently stable over time to be treated as a fixed calibration parameter. Preliminary life-cycle assessment indicated that the printed resistor approach can reduce panel-level CO2 emissions relative to conventional NiCr embedded resistor foil technologies. The results demonstrate that substrate planarity, surface height measurement, and interface control are key requirements for repeatable direct-write fabrication of printed embedded resistors.
Source: IMAPSource Proceedings
DOI: 10.4071/001c.173030
Institution: University of Massachusetts Lowell
Language: English
Subfield: Electrical and Electronic Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: bronze
OpenAlex ID: W7225317283
