Work

Metrology-Oriented Source-Point Sampling for Feature Continuity in Industrial Laser-Scanned Point Clouds

Year: 2026
Type: preprint
Abstract: Industrial laser scans are frequently reduced before geometric inspection, registration, and pose estimation. Such reduction can preserve broad surface coverage while interrupting the source-point sequences that support the estimation of hole rims, slots, interface edges, and related functional features. This paper presents a metrology-oriented source-point sampling method for industrial laser-scanned point clouds. The method assigns retention priorities to acquired points through a topology-guided protection field that combines local feature evidence, propagation along connected boundary segments, association across separated fragments, and attenuation outside feature regions. The selected cloud therefore remains a subset of the measured coordinates, rather than a set of generated replacements. The method was evaluated on ABC-derived workpieces, a controlled standard gauge, and high-voltage battery connector scans using reconstruction-oriented error, feature retention, edge-continuity dispersion, ablation tests, transfer without target fine-tuning, and a pose-oriented connector case study. At a 25% sampling rate, connector scans achieved 99.6% normalized feature recall and an edge-continuity dispersion of 0.0008. The pose case study reported a mean angular error of 3.77 degrees for three evaluated connector features. The results show that continuity-aware source-point selection can retain measurement-relevant boundary evidence under data reduction for the evaluated industrial scans.
Language: English
Open Access status: green
OpenAlex ID: W7226036620
Cites: 8
Cited by:
Related to: 10