Year: 2026
Type: preprint
Abstract: Joint encoders of rock-breaker booms sit at exposed pins, where impacts and falling rock damage them. This article controls a hydraulic rock-breaker boom using protected link-mounted inertial measurement units (IMUs) after a one-time calibration. Building on a pairwise complementary filter, each joint observer transports the specific forces of the two adjacent IMUs to the joint point with each link's own gyro rate, so that the joint-angle measurement depends on no estimate. A common Lyapunov function proves the confidence-weighted proportional--integral observer input-to-state stable for arbitrary weight trajectories above a floor, within an explicit error region, and because control errors do not enter the observer, observers and virtual decomposition control (VDC) form a cascade: the boom-joint loops are proved regionally input-to-state stable with the pressure-compensated valves modeled as velocity sources with delays, gain mismatch and dead zones, including online tuning. An auto-tuning procedure identifies each valve's joint assignment, flow gains, dead zones and loop delay through the feedback in use and sets the position gains to satisfy the stability condition. On a 10-t Rambooms X88-540-R boom, the observer deviated from the encoders by 0.07--0.11 degree RMS, and with IMU-only feedback the boom joints tracked a strike-cycle sequence within 0.12--0.21 degree RMS.
Source: Research Square
Institution: Tampere University
Language: English
Subfield: Mechanical Engineering
Field: Engineering
Domain: Physical Sciences
Open Access status: green
Funder: Tekniikan Edistämissäätiö
OpenAlex ID: W7236289153
